Finally almost ready to get my chassis power coated, justy a few things left to do.
Stamping the VIN being one of them (I already have a VIN from the DVLA). Not too keen on stamping a tube for all the reasons discussed many times before.
My pedal box is however made from 3mm steel so shouldnt be a problem to stamp.
I was thinking of stamping the VIN vertically up the corner of ther pedal box in the area highlighted.
Description
When I make the pedal box cover I'll make sure the VIN isnt covered.
My interpretation if the IVA manual suggests this would be ok, however I thought I'd see what everyone else thought.
Paul
[Edited on 28/4/18 by paulc]
