Evening,

does anyone know the thread size and pitch on zzr1100 sprocket output from the gearbox?

mines come off inside the prop UJ and need a new one for the weekend! very lucky not to have a bad accident. make sure yours is tight!

My prop came off when I had the same happen to me. Brown trousers moment when I realised it was the prop and not a knackered gearbox! Locking washer in place ever since!

20mm nut not sure om pitch but i doubt if they are ready avalible as its a fine thread shame i didnt see this before as i could have taken mine off and lent it to you bu cant get there untill tomorow night

Thanks for the replys gents. Confirmed it's an m20 fine.

Yep thread lock, locking tap and lock wired when it goes back on! Could have been very nasty!

Close one, if its the same as the ZX9 i think i have a spare one if you are stuck i can check tonight when i get home.
I got mine from a place in Washington near B&Q a couple of quid.

Please mate,

What was the place?

Hi,

These if you need any nuts or bolt another place is just round the corner.

http://www.google.co.uk/url?sa=t&rct =j&q=&esrc=s&frm=1&source=web&cd=2&cad=rja&uact=8&ved=0CDUQFjAB&url=http%3A%2F%2Fwww.dpfasteners.co.uk%2F&ei=Y 6ZPU5_MK-Ww0AWOo4HoBg&usg=AFQjCNH7Chks87cho1LpK_lacUz_aH70DA

[Edited on 17/4/14 by kj]

DP fasterners
14 Donkin Rd, Washington,
Tyne and Wear
NE37 1PF
0191 417 7846

[Edited on 17/4/14 by kj]

Found 2 but look smaller, at croft tomorrow morning if you want them

Measured it best I can its about19mm inside

got one sorted matey, i think that will be the same size, m20 x 1.5 if I'm not wrong.

many thanks for looking though!

No problem glad you back on the road

drilling the jets out to 2mm following suggestions from a friend looking forward to getting it on full chat

Any video need final push

my bloody dad does all the go pro stuff and every time we have been out he's never recorded a thing!

hopefully be out at the weekend and will take one then to send over

Enjoy the weather