Hey, I have a Caterham exhaust (single pipe, mounted aft if a 4-1 collector, to clamp on just inside the body panel), with a can (Cheeseman made, official Caterham supplier), with cat fitted into the can, and with the 45 degree flared end, sizes:

- 57" long, front to back
- 34" long shield in painted black, with clips intact to fit it around the can
- front end is clamp fit, approx 2.25" diameter

- Mild steel, the main can body seems like it would polish up nicely
- 2 mounting points, one at the front of the can, one on the 45 degree elbow near the outlet

Believed to have a cat, but no lambda sensor, and no way to open it, so not repackable. All welds look good & solid.

Never run it, but it looks and feels well built.

Say £100, could be awkward to post, so collect might be easier, from Stone in Staffs.

Please u2u an email address for photos.

Thanks
Ad