Board logo

220mm Friction Plate
tomduffield13 - 18/7/17 at 07:32 PM

Last part for my Pinto to Duratec with Type 9....

I'm using an ST150 flywheel and Pressure Plate, looking for the matching Friction Plate, 220mm, 23 teeth 1 inch Type 9 centre.

Has anybody got one lying around before I purchase a new one?

Thanks.

peter030371 - 19/7/17 at 10:24 AM

Will your old Pinto plate not fit or is it worn out?

tomduffield13 - 19/7/17 at 07:43 PM

quote:
Originally posted by peter030371
Will your old Pinto plate not fit or is it worn out?


The Pinto one is 190mm which is considerably smaller... I assumed I would need the correct size...

peter030371 - 20/7/17 at 08:59 AM

quote:
Originally posted by tomduffield13
The Pinto one is 190mm which is considerably smaller... I assumed I would need the correct size...


Must be two 'standard' size Pinto plates then as mine is 215mm and is working fine after 50 miles on a Duratec to type 9 install

tomduffield13 - 20/7/17 at 09:07 AM

quote:
Originally posted by peter030371
quote:
Originally posted by tomduffield13
The Pinto one is 190mm which is considerably smaller... I assumed I would need the correct size...


Must be two 'standard' size Pinto plates then as mine is 215mm and is working fine after 50 miles on a Duratec to type 9 install


I think the older Pinto were 190mm, with the later being 215mm. If i can't find a 220mm, i'll go with the Pinto.

I think the Mk1 Mondeo 1.8 Petrol were 220mm with the correct 23 teeth for the type 9....

Can anyone confirm?

snapper - 25/2/18 at 01:24 PM

Pinto 1.6 engine has a smaller clutch which is probably the 190mm you measured
2.0L is 216 mm with a clutch cover bolt PCD of 245mm

Fiesta ST150 has a clutch friction plate 220mm and a cover with PCD of 240 mm

I’ve just bought a Mondeo/S Max clutch cover and plate with PCD of 250mm which is what my lightweight Duratec flywheel is drilled for, I haven’t received it yet so don’t have dimensions of clutch plate

snapper - 9/3/18 at 10:16 AM

quote:

I’ve just bought a Mondeo/S Max clutch cover and plate with PCD of 250mm which is what my lightweight Duratec flywheel is drilled for, I haven’t received it yet so don’t have dimensions of clut


Which does not fit my flywheel because the friction plate centre is to wide and the clutch cover is for a raised lip DMF
Aaahrg

big_wasa - 9/3/18 at 11:40 AM

Yes the mk1 1.8 mondeo has a 220mm clutch with the 1" 23 spline centre as it used the mtx75.

The mk2 still has the 220mm clutch but has a smaller centre as it was fitted to the lower duty ib5 box.

I could probably find a part number on the box in the shed of it would help.