Set of four RS 7 spoke Capri alloys. 13 x 7 inch. 108 x 4 PCD ET5. Backspace is 107mm. I had these used ACB0 slicks mounted to these rims many moons
ago and haven't had the balls to use them. My Phoenix is fast enough for me on ACB10s, thankyou very much. The tyres are part worn and came in a
job lot with some others. Fronts are 6/21-13, rears are 7/22-13. They have been stored in the dark but I can't really vouch for their suitability
for use. That's up to you. One of the fronts has some fine lines across the tread but they don't look deep to me. Basically, the tyres are a
free gift to the buyer of the wheels. They are fully balanced and even have dustcaps but no nuts. I am near M1 J27
Im pretty keen on these but am nearly 3 hours away in DA1 (J2 M25)
If I buy them, could you hold them until I can get up to you?
^^^^ U2U sent.
To give an idea of how they fit under Phoenix bodywork...
This was the only time the slicks were ever put on the car.
I have checked the ET for my Striker and these are going to stick out too far.
I have U2U SPYDER regarding this so this is a bump for him and to the forum that these are still up for grabs.
Good luck with the sale.
Let's get these sold. £150
I'll take offers on these, as long as you offer £125
Have you got these advertised elsewhere? These will go for more, I recon, on a classic ford forum. Or eBay even. Starting at £125 I would be shocked if these don't sell.
They're on a FB kit car group and on PH as well as FB general marketplace. I thought they would sell at £200! They'd be spot on for Santa
Pod or for a trackday kit if you have bigger balls than I have. Maybe people just aren't buying at the moment.
I've got a set of GSXR throttle bodies for sale cheap too with a similar lack of interest. Normally they would sell quickly.
Do you know how heavy they are?
quote:
Originally posted by Bunje
Do you know how heavy they are?
Deposit taken.