Hello
I am in a situation that does not allow for any room for the tube "R" (From the upper suspension mount to the rear of the engine compartment).
A few years ago on this site I saw someone made a bolt in ring that went around the valve cover and acted like a strut tower. I have been searching but cant find it.

If anyone can point me towards it I would be greatfull.
Thanks
Dale

I think you're referring to the bloke who put a V6 into a locost - James as i recall. But this was probably 10 years ago.

I found the posting , it was by Steve Hignett, I have not found a pic of the chassis with the engine in it yet though.
Dale

Your post inspired me. I was actually thinking of liam.

Post about his car part way down the following link & then click on the link by him name for his photo archive.

http://www.locostbuilders.co.uk/forum/4/viewthread.php?fid=2&tid=168630

Yes that is the one. Thanks. The one I found is similar but I think for a bec. I ahace accord Lima 2.3 turbo which should end up good ving me around 250rwh and 300 or so torque. I don't want it to flimsy out fron . Thanks again.
Dale