Printable Version | Subscribe | Add to Favourites
New Topic New Poll New Reply
Author: Subject: Rear round trim?
the_big_1

posted on 20/6/20 at 08:25 PM Reply With Quote
Rear round trim?

hi all,

I was looking at using the aluminum hockey stick type trim form my side trim along the area your arms would be, but can you mould it to fit the round part level with your shoulders or have you used something else???

View User's Profile View All Posts By User U2U Member
bigrich

posted on 21/6/20 at 07:52 AM Reply With Quote
If you cut a small relief notch in the hockey stick on its curved edge you can the bend it at the point it goes up towards your shoulder and form it all in one piece









A pint for the gent and a white wine/fruit based drink for the lady. Those are the rules

View User's Profile View All Posts By User U2U Member
40inches

posted on 21/6/20 at 09:08 AM Reply With Quote
I made a former out of MDF and clamped it in the vice, it bent relatively easy.
If you haven't panelled the inside yet you can bend it on the car using G clamps


Description
Description

View User's Profile View All Posts By User U2U Member
the_big_1

posted on 21/6/20 at 09:51 AM Reply With Quote
Did you have to use reliefes?
How do you do them without them looking horrible lol

View User's Profile View All Posts By User U2U Member

New Topic New Poll New Reply


go to top






Website design and SEO by Studio Montage

All content 2001-16 LocostBuilders. Reproduction prohibited
Opinions expressed in public posts are those of the author and do not necessarily represent
the views of other users or any member of the LocostBuilders team.
Running XMB 1.8 Partagium [ 2002 XMB Group] on Apache under CentOS Linux
Founded, built and operated by ChrisW.