Board logo

Tube bending
Simon - 22/8/03 at 12:23 PM

Just found this and thought it may be of interest to peeps on here!

http://www.pipecraft.co.uk/

ATB

Simon

stephen_gusterson - 22/8/03 at 11:01 PM

interesting site, but way over the top special effects - would cripple a dial up!

atb

steve

spy - 22/8/03 at 11:44 PM

I've contacted them recently. They're quite expensive. They quoted me about £220 for a roll hoop with 4 bends.

The guy I spoke to said that a lot of the cost was due to the fact that he had to order a full length of tubing to do my design.

Alan B - 23/8/03 at 12:35 AM

quote:
Originally posted by stephen_gusterson
interesting site, but way over the top special effects - would cripple a dial up!

atb

steve


Agreed.

I gave up after the first couple of pages.
Why do people do that? The first fancy site you see is cool.....but now I just want info. not a hollywood production......

Just another rant I guess....

kiwirex - 23/8/03 at 08:45 AM

Originally posted by stephen_gusterson
interesting site, but way over the top special effects - would cripple a dial up!

Ta for the warning

- Greg H

carcentric - 24/8/03 at 08:11 PM

I found this interesting (and no graphics at all): http://btw-trikers.org/wwwboard/messages/2785.html

Ian Pearson - 29/8/03 at 04:46 PM

Had a few bits from Pipecraft. Not cheap, but very well fabricated. Dealt with a guy called Andy Wood. Best contacted privately on his mobile during lunch, as they are normally busy. See my post on manifolds.