Hi all im having a little trouble finding something out.
I was wondering if stub axle splines are standardized in the same way as drive shaft splines???
Ie: For drive shafts a any 25 spline shaft will fit into any 25 spline CV there is no range of different diameters (at least acording to the man at
GKN i spoke to the other day.)
So is this the same for Stub axles? reason i ask is i have a ford hub (27 spline) and i am wondering of it will fit a 27 spline stub from another
manufacturer????
cheers
tilly
Only way to tell is if you have a stub axle and the other hub available to try (or measure).
Diameters could be different but with same spline count.
Also stub axle length and bearing distances could be different.
im not worried about the length or bearings to be honest, but i would thought there would be some sort of ISO or ANSI standard for the splines
Tilly
This site seems to imply that it is only the spline count that changes as different diameters are not mentioned at all
http://www.kartek.com/product/DriveTrain/StubAxles.html
quote:
Originally posted by tilly819
This site seems to imply that it is only the spline count that changes as different diameters are not mentioned at all
http://www.kartek.com/product/DriveTrain/StubAxles.html
Ok guys, well im off to the breakers in the morning so il take a hub to try, fingers crossed
tilly
Most (not all) auto splines are SAE form. There's a metric and an imperial version, so go with care, as sometimes they have been mixed to suit
the end product.
Cheers,
nev.