So after sitting dormant for a few years and numerous attempts to re-kindle my enthusiasm its come to the point where i am selling up so everything must go. Main items are as follows but there may be others that come along as i clear out.

All prices are items only and collection from where stored just outside Oswestry, Shropshire. I can take some smaller items to Wrexham where i work if easier. I can also arrange postage at additional cost, please U2U me to discuss. I do have photos if people wish to see however i am struggling to upload them at the moment.

Please drop me a U2U if interested in items

• Chassis – Mcsorley based – purchased as a kit from ebay which was laser cut by armoto to the mcsorley dimensions so high accuracy dimensionally. Roll bar is an OBP produced from CDS with additional seatbelt bar (not yet welded in). Trailing arm, wishbone and steering rack mounts in place. I was in the process of doing shock mounts and seatbelt mounts so have some plates cut for those. Engine and gearbox mounts are in place to suite the zetec and type 9 . Welded steel floor. The chassis has some surface rust from standing in the garage which i was in the process of removing but didnt complete. Still needs some welds tidying up and finishing so not in a condition to just bolting kit to. - £200

• 1.8 zetec engine – purchased off ebay from someone who was going to retro-fit into his caterham but then sold the car. I was informed it had done roughly 50k and it turns by hand. Never taken the head off so unsure of condition other than that. missing rocker cover bolts. - £80

• *SOLD SUBJECT TO PAYMENT* Type 9 gearbox – purchased off locostbuilders and in good condition – all 5 gears and reverse select easily. - £80

• Shortened Ally sump for Zetec Engine - £50

• *SOLD SUBJECT TO PAYMENT* Inlet manifold for zetec engine for ZX9R bike carbs - £60

• English rear axle – has the mounts welded on and had a full rebuild when i got it of seals and bearings in both the ends and the diff. Ill throw in the trailing arms and rose joints too - £100

• Front trailing arms BRAND NEW – Rally design items & powder coated. - £150

• Front uprights – Cortina – stripped and were cleaned using electrolysis. Just need a wire brush before finishing & bearings. - £90

• Steering rack. BRAND NEW – Rally design 2.9 quick rack including rod ends and mounts - £90

• *SOLD* OBP pedal box BRAND NEW – dual master cylinder with cable clutch including 2 cylinders - £120

• Sierra steering column – full column set including steering wheel and surrounds - £70

• *SOLD* Front headlights BRAND NEW – traditional 7 style including side light - £30

• Lucas LRA101 alternator - £20

• *SOLD SUBJECT TO PAYMENT* Lucas starter motor - fits the Type 9 box - £20

• Polo radiator - £20

[Edited on 9/2/16 by luke]

I'd like the bike manifold and the ally sump ( has it go a front bowl or rear bowl )
First dibs please
And the starter please
Steve

[Edited on 7/2/16 by Lightning]

Is the quick rack shortened or full length?

can i have the engine

[Edited on 7/2/16 by emwmarine]

How much for postage on the type9?

Think i have U2U'd you all with your answers. Anyone else have any interest can you U2U me please

Thanks

Luke

If the type 9 is still available I'll have it please collection one night this week?

Got my pedal box today perfect just what I wanted Many thanks

*BUMP*

any further interest before it goes on eBay?

Luke

Did starter motor sell?

U2U x 2 :-)

[Edited on 29/2/16 by Dudefladge]

Hey Luke,

Do you still have the McSorley chassis and suspension parts for sale? I notice you haven't yet read my last 2 U2Us.

Thanks!

Rob

Trying again before focusing on an eBay or other purchase...

Do you still have your chassis for sale?

Does anyone in the Oswestry area know luke and could possibly give him a nudge for me..?

Have u still got steering rack ? Can u measure the overall length please ? Thanks