Board logo

Stuart Taylor ZX9R BEC Project
Wadders - 22/4/18 at 09:41 PM

Was a well sorted car in it's day, built with all the right bits, and could mix it with the bigger boys on track, however i blew it up at Cadwell around 8 years ago, i quickly dropped a replacement engine in, but then for one reason or another it went into storage on a mates farm where it's been until spring last year when i retrieved it from the corner of a dusty barn, despite being covered by a tarpaulin it was full of straw, leaves bird poo and spiders etc

The intention was to revive it and do some track days, but it's just not happened, i made a start, but my heart's just not in it any more. Have considered breaking it, but would rather it went to a good home, it really was a good car. Handled exceptionally well and did a 12.99 sec quarter at York on 888's

The years in storage have taken their toll, bodywork is tatty and any bare metal parts have surface rust on them (brake disks etc)
it's only superficial, i cleaned up one disk in a matter of minutes with a scotch-brite pad. The stainless exhaust has taken a knock and is split, but would weld up ok.

i put a new battery on and the engine fired up straight away, but it's running at a really high tick over, carbs will require stripping and cleaning, the petrol in it is 8 years old (looks more like diesel) so needs dumping.

In short it needs a good fettling to revive it, however due to other automotive interests i've not got the time or inclination so am offering it for sale, will make a great car for someone willing to put in a bit of effort, a good weekends work would do it.

Spec as follows......

Stuart Taylor IRS chassis and wishbones
Polybushed all round
AVO Shockers
Quick rack 2.2 turns
Cortina uprights
Alloy Front hubs
Willwood Alloy front callipers
Braided brake lines
Yellow box speedo healer
Roll bar
Alloy fuel tank
Alloy side panels

ZX9R E Engine
Billet Sump Kit
Dynojetted carbs, RR tuned at Holeshot
Paddle shift with Flatshifter and Auto downshift blip
Two piece prop with centre bearing.
Sierra 3.14 Diff with Quaife LSD
Billet custom driveshafts by GB Engineering
Alloy rear Bells with Fireblade discs and alloy Peugot callipers

3 Piece Compomotive split rims
Carbon Aero cycle wings
Carbon Kevlar seats by Playskool Motorsport
10" Quick release suede steering wheel
Adjustable brake bias
MK Indy rear panel
MK aeroscreen
MK Bonnet scoop
Willans 4 point harnesses with pads.

Reckon i had £12k plus in the build, and it would probably break for £5k, so looking for offers in the region of £4250

Car is in Leeds West Yorks and will need trailering away.

Photos of it when it came out of storage can be seen here

https://www.flickr.com/photos/151119882@N04/albums/72157682170713111

This is what it looked like in it's prime Description
Description


Thanks for looking.

Alan 0781 0002549


wylliezx9r - 23/4/18 at 12:08 PM

I take it the car isn't registered ?