Morning all,
A while back I fabricated myself a wheeled trolley for my MIG welder using box section tube. On the rear I built a low "shelf" arrangement
for the gas bottle to sit on. The bottle is then tied to the trolley with a couple of ratchet straps. This works, but I'm thinking it should be
better supported.
Quite happy to weld more parts etc.
Does anyone have any suggestions or perhaps pictures of how there's are done?
Thanks,
Nick
I welded some 6mm steel bar on the back. If i change bottle size ill just grind it off and weld a new piece on
Thanks - certainly feasible with what I've already got!
My bottle is held in place with a large worm drive band. Worked ok for the last 20 years 
My machine has a chain which wraps round the bottle on hooks each side, supports a 50L bottle ok.
Getting my Argoshield bottle refilled in the next week or so which frees me up to make modifications to the trolley 
quote:
Originally posted by r1_pete
My machine has a chain which wraps round the bottle on hooks each side, supports a 50L bottle ok.