I've been doing the wiring on the blade engine but I havnt got a spark I've got power to the coils but that's it all the wires are connected when I test the ecu plug not all are live or earthed. Any help would be good. My ecu has 12 wires if that helps. Cheers

[Edited on 4/4/14 by Nurburg2006]

[Edited on 4/4/14 by Nurburg2006]

IIRC you need to ground clutch sidestand etc inhibitor switch wires, again, from memory I think all these are green with various tracers.
Have you a circuit diagram? I may have a jpeg somewhere...

Thanks for your reply I have a diagram for it cheers all green wires etc to ground the engine came out of a kit car so most of the wiring is joined up so it should have been a straight forward job to plug and play.

What have you done with the pink wire?

I don't have a pink wire. .??

Stupid question but have you actually got an earth strap to the engine.... It's quite easy to forget to connect the big black cable after hous of fiddling with tiny wires!

Just realised that if the starter is turning then you must have an earth strap.

Still no spark any help would be good. Cheers

Bump