All,
as this forum is the font of all knowledge.
We're regrouting the floor tiles in my gf's kitchen. They're large ceramic tiles, about 20x40cm each, and with 5mm grout.
There's probably about 4x4m area to do.
We had to have a few tiles up to replace due to cracking, so I've cut the grout away to get them out but what a ball ache of a job!
Is there a better way?
I've got an oscillating Bosch multi-tool with a grout removal carbide attachment, which is okay, but it's about 2mm wide, and takes a while
to get through. I struggle to get it out to both edges of the tile (since grout width is 5mm), and am worried about chipping the top surface off the
tile (this happened on a couple of tiles when chipping away the cracked ones).
What's the recommended method/tool?
Thanks,
I use a diamond disc in my angry-grinder,... awesome, quick and very clinical
I sit next to a ex proffessional tiler in my office and he reckons there is not a easy way. Angry Grinder and a dust mask.
+1 for angry grinder! You can use tape to try to protect the edges or use a wooden batten as a guide but I managed to do an entire bathroom floor free-hand with the grinder and didn't ruin any tiles.
Thanks all, will give angry grinder a go (I've got a diamond disc for it already) - have a few spare tiles if it all goes a bit tits up 
The hard bits are where I end up with a T grout bit as the tiles are staggered, need to avoid cutting past the T into the tile.
Be aware the dust will get into every nook and cranny in the house. Seal up the door to the rest of the house with tape, including teh bottom of the door. You have been warned! (this is my experience of using a grinder in an occupied house. It took a loooong time to be forgiven for that one)
quote:
Originally posted by cliftyhanger
Be aware the dust will get into every nook and cranny in the house. Seal up the door to the rest of the house with tape, including teh bottom of the door. You have been warned! (this is my experience of using a grinder in an occupied house. It took a loooong time to be forgiven for that one)
i'm a tiler, removing grout is one job i try and avoid. if i have to do it i use a multitool and attachment your using.
grinder is to dusty, cant get into corners and is to easy to catch a tile edge.
get as close as you can to the tile edge without catching it and then running a knife blade along the tile edge will normally remove any last bits of
grout if you've taken enough out of the joint.
the dust from a very narrow diamond blade has never been an issue, I run a vacuum near cowl, very neat and tidy, and extremely quick. Agree that it
wont get into the corners, but it is quick on the long straights,....
quote:
Originally posted by bigfoot4616
i'm a tiler, removing grout is one job i try and avoid. if i have to do it i use a multitool and attachment your using.
grinder is to dusty, cant get into corners and is to easy to catch a tile edge.
get as close as you can to the tile edge without catching it and then running a knife blade along the tile edge will normally remove any last bits of grout if you've taken enough out of the joint.