Board logo

Megajolt Pinto Map
TrophyJem - 1/6/12 at 03:46 PM

I've just got my Megajolt installed and now need to put a map on it as a starting point.

Has anybody got a map they are happy with for the Pinto that they would care to share?

The engine is;

2.1L Pinto
FR32 cam
Large valve head
Twin 40 Dellortos with TPS

Cheers

se7ensport - 1/6/12 at 04:27 PM

I used the following with great success on my old Pinto, it had a large valve heavily skimmed head with FR33 cam and bike carbs initially and then GSXR throttle bodies. I don't have an exportable format that will work with megajolt, but you can transpose the figures easy enough, usual comment applies about shared maps etc: no two engines are the same, my trigger signal could be in a different place than yours, listen out for pinking, use with caution etc...

Pinto map
Pinto map

Pinto map 3D
Pinto map 3D

shaft - 1/6/12 at 05:55 PM

I have a map i can email to you.

It was tweaked on the rolling road.

Spec:

2.0l Pinto, Blade carbs, FR32, Big valve head.

U2U me your email and i'll send it over for you.

TrophyJem - 1/6/12 at 06:11 PM

quote:
Originally posted by se7ensport
I used the following with great success on my old Pinto, it had a large valve heavily skimmed head with FR33 cam and bike carbs initially and then GSXR throttle bodies. I don't have an exportable format that will work with megajolt, but you can transpose the figures easy enough, usual comment applies about shared maps etc: no two engines are the same, my trigger signal could be in a different place than yours, listen out for pinking, use with caution etc...

Pinto map
Pinto map

Pinto map 3D
Pinto map 3D


Thanks for that. I guess I might need to tone it down a bit from your settings.

shaft - 1/6/12 at 06:19 PM

Map sent via email.

ryanill - 5/6/12 at 08:05 AM

Hi all

Sorry to hijack this thread but any of you guys got a base map for a standard pinto on bike carbs ?

Iv recently put a mega jolt in my Indy. Now need a map to

Any help would be great


Ryan

mcerd1 - 5/6/12 at 09:16 AM

^^ any twin carb map should be a good enough starting point

here's a few I've collected:
Pinto Maps Linky

ryanill - 5/6/12 at 09:21 AM

Cheers for the link

Got something to do on the bank holiday now

Ryan

ryanill - 5/6/12 at 09:33 AM

quote:
Originally posted by mcerd1
^^ any twin carb map should be a good enough starting point

here's a few I've collected:
Pinto Maps Linky



just noticed that the load values go over 100%
is the because they are for a engine with a MAP rather than a TPS ?

ryan

mcerd1 - 5/6/12 at 09:58 AM

some of them might be for a MAP version, they are ones I picked up from a few different sources

you can easy change the setting to TPS and adust them from there