Does anyone have drawings/dimensions for a set of Zetec engine mounts (to go into a westfield narrowbody)? The usual two plates with an angled tube between them.

I can't easily mock the engine up in the car, but wanted to get all the mounts welded at the same time as I do the rest of the welding bits on the chassis.

Thanks

If anybody does have a set of these, could I have a copy too, please?

Regards
Jon

I lowered the engine in am made mine to suit

Are there some zetec drawings in the latest tiger Avon book? Not sure they are correct for your car but worth a look, also seen some laser cut plates on auction site to suit zetec