Board logo

Pedal Box Setup Help
Tiger Super Six - 8/12/09 at 10:39 PM

Evening,

I have just bought this floor mounted pedal box

http://www.3gecomponents.com/templates1/view_product.php?product=51748&site=63&department=118

and need to figure a way to adapt the sierra pushrod to fit the brake pedal as it has a hole through it, but the sierra set up fits front on (if that makes sense) - Any Ideas?

Also I need something to clamp the clutch cable?

Mark.

Ben_Copeland - 8/12/09 at 10:52 PM

All you need is a clevis pin and threaded rod as a pushrod.

Back of the brake pedal already has the hole for the clevis pin





[Edited on 8/12/09 by Ben_Copeland]

Staple balls - 8/12/09 at 10:54 PM

Clevis for the brake pedal.

You can get clutch cables with banjo type fittings on the end, might be the easy way for that.

Tiger Super Six - 8/12/09 at 11:01 PM

Cheers chaps - Brake sounds simple then, any idea of the thread the Sierra pushrod will be and any tips on where to buy?

Is there a pic of the banjo style for a numpty like me to refer to!

[Edited on 8/12/09 by Tiger Super Six]

Staple balls - 8/12/09 at 11:11 PM



Shamelessly stolen from www.burtonpower.com

Tiger Super Six - 8/12/09 at 11:20 PM

Thanks

Ben_Copeland - 9/12/09 at 06:56 AM

quote:
Originally posted by Tiger Super Six
Cheers chaps - Brake sounds simple then, any idea of the thread the Sierra pushrod will be and any tips on where to buy?

Is there a pic of the banjo style for a numpty like me to refer to!

[Edited on 8/12/09 by Tiger Super Six]


throw the sierra one away it'll probably be the wrong length anyway. Use a suitable size metric threaded bar. Can't remember the exact size, someone will remember for you. Round the end off that goes into the master cylinder.

Tiger Super Six - 9/12/09 at 09:27 AM

Thanks.

Ben_Copeland - 9/12/09 at 12:51 PM

Think it's 6mm bar