Miks15
|
| posted on 2/1/10 at 10:10 PM |
|
|
indy chassis rail height
can someone tell me the height of the chassis rails on an mk indy, cheers
|
|
|
|
|
stevec
|
| posted on 2/1/10 at 10:39 PM |
|
|
Its variable, so I am not sure what you mean.
Steve.
|
|
|
Miks15
|
| posted on 2/1/10 at 10:41 PM |
|
|
where the scuttle sits, from the bottom of the bottom rail to the top of th top rail.
|
|
|
stevec
|
| posted on 2/1/10 at 10:59 PM |
|
|
I have measured from the bottom of the chassis rail to the top of the chassis rail in the engine bay as near as possible to the scuttle and it is
35cm.
Steve.
|
|
|
Miks15
|
| posted on 2/1/10 at 11:04 PM |
|
|
ok great, is it the same heigh from there back to the scuttle, i believe from the scuttle back it drops, so i assume the chassis rails are parallel
from the front to the back of thescuttle?
|
|
|
stevec
|
| posted on 2/1/10 at 11:46 PM |
|
|
If nobody else responds i will have a look in the morning, bed time now.
|
|
|
Miks15
|
| posted on 2/1/10 at 11:54 PM |
|
|
many thanks steve, much appreciated
|
|
|
stevec
|
| posted on 3/1/10 at 12:06 PM |
|
|
It is a bit tricky to check but it very much looks like the top and bottom chassis rails are parralell from the front of the scuttle along to the
bottom edge of the dash, then they start to close towards the rear.
Steve.
|
|
|
indykid
|
| posted on 3/1/10 at 12:27 PM |
|
|
i was under the impression the indy had 14" sides to fit a pinto, whereas a locost has 13" sides.
the side rails are parallel from the front to the back of the scuttle where they drop towards the back arch.
tom
|
|
|
Miks15
|
| posted on 3/1/10 at 05:56 PM |
|
|
ok thanks guys,
|
|
|
