have wired the indicators this morning.
i can get all the indicators to work but the hazards in pairs ie disconnect the fronts and the rear lights work and vise versa
any ideas,am using 5vy loom and switchgear
andy

I think you need to change the bike relay to a 3 pin and wire up as described on previous posts

You can get it to work with the bike two pin relay, check what rating relay it is. My zx10 one was 10 amp and would not run all the indicators, just got an initial flash then nothing with everything connected. I had one from my old zx9 loom that I'd not used it was the same fitting but 20amp, pluuged this in and everything was fine

Andy