Does anyone has an haynes manuell about the wire loom, I can't seem to figger out where all the connectors are going too...
And also I have bought a '98 zx9r speedo and my question is, is it possible too use this speedo in regards to the speedsensor that gets it's readings form the front sprocket.

ive got the full diagram laminated in a3, for all years of zx9. Got any specifics question?! no idea about the speedo though.

There is a wiring diagram for an 'E' model ZX9R in my pic archive. It is similar to the 'C' model so it might help. If I remember I will scan the 'C' diagram later this week.

Dave

If you could post it, you would make me verry Dave.

[Edited on 10/10/05 by badding]

sorry, thats massive... any smaller and its not readable though.

moved to my archive


[Edited on 10/10/05 by JoelP]

Is the zx9r E model engine the same as the zx9r C in regards to the wiring.??

it would appear to be broadly similar in the wiring layout, but i couldnt comment on things like connector compatability.

Oops I've just remembered I was supposed to scan the wiring diagram.

When I got my engine I was told that it had everything to get the engine running except the ECU. I later found out that with my 'E' engine I had all the 'C' running gear! The wiring is similar and from what I remember the connectors are the same but the 'C' has a cam shaft sensor and only one headlight relay. I made a seperate loom for the engine and one for the lighting then spliced them together. With the 'E' wiring diagram you could make a start.

Dave

had also an cam pos sensor?

are both injection?

Tks