Hi All,

Sorry I can't put a picture up at the moment but it says "unsuported file".

I've a plug with six black wires and a another plug with three black wires.

The six black doesn't plug into anything but show "alarm" on the wiring diagram. The three pin plugs into a fuse then it's snipped.

Is it as obvious as an alarm box and what about the other plug ??

Any ideas ?

Cheers, Lyn.

change the file to jpeg
or its to big to upload

have you got loom powered up to check

it's for the cycle lok not the alarm a bit like a bike immobiliser, have a look under r1 cyclelok in the archives there shoul be some old info there.kev

I think it's too big, I took the picture at 7meg to get a really clear shot.

So it's the infamous cycle lock. I've just been throught the posts, anyone got a clear diagram or description, does every one have these ends open ?

Hi Lyn new one on me iv checked all my wire diagrams for 02/03/04 r1 not found it anywhere
looked under the archive and its thereso hope you can sort it
let me know
cheers malc

Thanks Malc,

I'll let you know once I've sorted it !

I'll be back tomorrow or saturday so if you are still stuck send me a U2U and I'll trace what you need to loop on my loom. If you look in my archive I have a diagram of my six pin plug which says what goes where and what to loop. My 3 pin was already looped.