hi im a bit stuck wiring my ignition (fuel injected r1, ive sorted the stop switch. the bit im stuck on is the red plug which would have gone to the ignition barrel on the bike , there are three wires brown/red blue/yellow and a black/blue, what do i do with them?

[Edited on 7/6/06 by adrian]

can anyone help

Hi.
I'm not near my engine. As soon as I take a look at it I'll get back to you.

Joao

Looking at the wiring diagram you should have two plugs each with two wires going to the ignition barrel. One plug (colour of plug unknown) should have a red wire and a brown/blue, and the other plug (red) should have a black/blue and a blue/yellow.

You should then join the red and brown/blue together, and then the black/blue and blue/yellow together seperately. This should bring on your ignition and also power for lighting etc.


[Edited on 9/6/06 by Coose]

Hi.

Red connector:
Blue/red and Blue is for PARK circuit, IIRC
Black --> Blue / Yellow

Main switch (White connector)
Brown / Blue --> Red

Blue connector [59]
Red /^Black --> Red White (Engine kill)

Blue connector [11] (Side stand)
Black --> Blue / black

[41] (Left handlebar)
Blue / Yellow -> Black yellow (Clutch)

Green connector [52] (Fuel pump)
To a new relay to command the fuel pump
Red / blue --> 85 (signal)
Black --> 88 (ground)

Best regards,
Joao

so do i permanantly join together the blue/yellow and black (black/blue on some looms) wires or should they be via a switch? ive cut out the lighting circuits

Just cut the wires...

I've cut all the lighting related wires and loom got quite thinner

Joao