I am fitting a accusump to a zx12r engine,

Has anyone done this or could they advise the best gallery to install it in.??

preferably a 1/2 inch gallery, i can only see one on the block + the oil pressure gallery. these look too small??

any advise greatly appreciated.

Sean

please please help??

Not sounding to desperate i hope.

Sean,

the blanking plug that goes directly into the main oil gallery (Opposite the OEM pressure sender) is 5/8" or roughly 16mm, so should be plenty big enough. Looks like this is also the best place to install the accusump - directly into the main gallery. Don't take my word for it though.

It's real tight to get the hex plug out though and you'll need a length of tube on your allen key for leverage to remove it.

Phil


[Edited on 12-9-06 by Hellfire]