There is a bolt, into the side of the cylinder head, right by the TPS on a 919 blade, at the gearbox output side end.

Anybody know what thread it is?

I'm thinking its an M10 x 1.25 but I can't find that I've ordered any of those from Namrick, only 7/16 UNF, so was it those?

ta
Chris

EDIT: Ok, pretty sure its M10 x 1.25 as its got a 17mm head on the bolt in there already.

[Edited on 25/9/06 by the_fbi]

It will deffo be metric, and prolly fine.

Definately metric fine, M10 sounds about right.