I've got all my wiring done now, thought i would see if i had a spark.
Tried a spare spark plug, no spark, i crossed the start/stop switch, red to brown/white, so took out the brown/white, tried again, no spark, but when
i put the brown/white wire back in ,a spark, so as i touched the brown/white to the red i got lots of sparks, but no spark when permanently spliced,
also, a hissing noise, coming from my cdi unit, and it got very hot, please dont say i've buggered that as well, help please.
Brad
sorry but it sound like you;ve killed the CDI.
do you have a wiring diagram for it? if your stuck i could pop over and give you a hand
Ray
[Edited on 29/4/07 by rayward]
Yes, i do have a wiring diagram, but theres not alot to change, i've spliced the stand switch, and the clutch switch, a feed from position two on
ign to start stop switch, connected start/stop wires together, 100ohm resister between brown and white, on original ignition, then fed the car loom
ignition to the starter relay, the only thing i can think of , is the wiring at the start/stop switch.
On the wiring diagram, there is two switches, one stop switch, and one start switch, these are fed buy three wires, red wire and brown/white to the stop switch, and red and black/red to the start switch, i have just jumped the red to the brown/white, is this correct.
It looks like i've connected the clutch switch wires wrong, i will try tomorrow and let you all know.
quote:
Originally posted by roadrunner
On the wiring diagram, there is two switches, one stop switch, and one start switch, these are fed buy three wires, red wire and brown/white to the stop switch, and red and black/red to the start switch, i have just jumped the red to the brown/white, is this correct.
Yes, but yours does'nt spark either Bri.
Have got a bike leccy 'guru' coming round on sat morning.Will let you know what goes where? (IF it start's!)
Earthed the clutch switch, still no spark.