Board logo

favour from someone with 06-07 zx10r
dan__wright - 12/12/07 at 09:11 PM

can you measure resistance between the pins on the top over sensor for me.

Thanks.

Paul TigerB6 - 12/12/07 at 10:14 PM

I'm getting a ZX10R (eventually) myself so hope you dont mind me asking - whats a top over sensor Dan???

Paul

ChrisGamlin - 12/12/07 at 10:22 PM

I assume tip over sensor? ie it cuts the engine if the bike is dropped on its side.

Paul TigerB6 - 12/12/07 at 10:29 PM

quote:
Originally posted by ChrisGamlin
I assume tip over sensor? ie it cuts the engine if the bike is dropped on its side.


Ah thanks Chris.
Why cant they stick to standard terms?? Kawasaki call that a "vehicle down sensor" according to the manual. They dont give resistance setting for that anyway - just voltage readings on the bike.

No help is it sorry

dan__wright - 13/12/07 at 08:46 AM

yeah ive got the dealer manual and it says to measure voltage out of it but thats not too helpfull at the mo, if someone could measure the resistance would be much easier.

dan__wright - 13/12/07 at 12:31 PM

thats what i was going to do but simplified, if someone could measure the restistance i wouldnt have to mess about with pots (dont have any at the mo)

dan__wright - 13/12/07 at 01:33 PM

is the ground used or is it just the supply > resistor > output?