Anyone know where I can get tube and bends in 35mm od (1 to 1.5mm wall) stainless to make an R1 manifold? Ideally not too pricey!

38mm is common but too big.
jk

like these.
Rescued attachment bends.jpg

Er... probably

Are they 35mm od and equally important, where are they from?

jk

35mm od, c/w 1.5mm wall in grade 316 stainless.

Sounds good. I'm a bit confused, are you selling these or am I missing a link to where I can buy them?

If you're selling them then let me know what you're after for them.

<edit> I just checked mine (it's not for my car) and they're 38mm anyway! I never realised it wasn't stock dia.

I'm still unsure where to buy them
jk

[Edited on 7/1/08 by jkarran]

so what size are you after, i did send you a u2u.

cheers, I just spotted the u2u, I must have my account setup wrong.

try www.zorstec.com well worth a look