Hi guys

I think I need a 1/2 inch master cylinder with 1.5 inch stroke for the busa clutch. I have fitted it up using the bike one which has a 1/2inch 1 inch stroke and its only moving the clutch rod about 4mm in. Is 4mm enough? Or shouid I go for a 5/8 bore cylinder? I am guessing the slave I have is bigger dia than the standard busa one.

Assuming I do need this 1/2" 1.5 inch stroke cyl, any ideas where do I get one from?

Thanks in advance
Jason

Thanks






[Edited on 7/2/08 by Jason Fletcher]

4mm might be enough, they don't need much to disengage....

I had a ZX9R B type with a hydraulic clutch and 4-5mm sounds about right