Really hoping some can help i have download a workshop manual but don't under stand how to balance my carbs ( position of the vacuum pickups and the adjuster)
thanks in advance for any advice.

I've got an idiots guide if that helps but it's in "word" format so I can email (or if someone tells me how to) I can post it

try this......

http://www.bikersoracle.com/zx9/forum/showthread.php?t=2375

[Edited on 29/4/08 by Eggy]

i am that idiot larrythelathe@msn.com
thanks

Just borrowed the wifes best slippers and had a peek in the garage

vacuum pipes are under each inlet manifold (little metal pipes with a rubber blanking cap on)
adjustment looks like the screws directly in between the inlets, looking down from the top, mine have a blob of yellow paint on the heads.

If your still struggling i'll try and dig out the haynes for you.

AL.





]Originally posted by larrythelathe
Really hoping some can help i have download a workshop manual but don't under stand how to balance my carbs ( position of the vacuum pickups and the adjuster)
thanks in advance for any advice.

Borrowed from MK9R's archive but I think these are the points you need? Someone correct me if not


Carbs Underside

[Edited on 29/4/08 by mistergrumpy]
Forget that I think thse are the drain points I'm digging for a better picture of some carbs.

[Edited on 29/4/08 by mistergrumpy]

i used my own shoes
i have a pipe that goes between inlet 1 and 4 and then blanked
i seem to have 3 adjusters is this right.
do i only need to measure the inlet on 1 and 4?

Have a look at this mate from another forum
here

[Edited on 29/4/08 by mistergrumpy]

at last th penny drops
thanks all

Have a look at the rest of the job here

As above!

i just wasn't getting it

anyone happen to know were to get some

vacuum take offs? for the blanked ports?

Mr Kawasaki - or his local friendly stealers!!