Gav
|
| posted on 20/9/06 at 11:10 PM |
|
|
Blade prop adaptor retaining bolt
Stuck the engine in tonight and attached the prop, but realised in missing the retaining bolt.
Found a M10 fine which seemed to fit nicely.
Whats the best way to actually stop the adaptor coming forward, was thinking of machining up something like a 2/3mm thick washer to clamp it down,
sound ok?
|
|
|
|
|
ch1ll1
|
| posted on 21/9/06 at 07:12 AM |
|
|
i used the original washer but was still play in it.
so i found a new one about 3mm think
|
|
|
tks
|
| posted on 21/9/06 at 08:19 AM |
|
|
mhh
I found out that my prop brought from ebay was to small!!
i needed to fit a spacer on the splined shaft and there on the adapter to be able to lock it!
else i would have play to!
the thickness of the washer is nothing though i think 0,8mm
Tks
The above comments are always meant to be from the above persons perspective.
|
|
|
shortie
|
| posted on 21/9/06 at 08:51 AM |
|
|
Some need a thicker washers than others, just machine the correct size up to ensure there is no play.
Rich.
|
|
|
