the_fbi
|
| posted on 25/9/06 at 07:50 PM |
|
|
919 Blade head thread?
There is a bolt, into the side of the cylinder head, right by the TPS on a 919 blade, at the gearbox output side end.
Anybody know what thread it is?
I'm thinking its an M10 x 1.25 but I can't find that I've ordered any of those from Namrick, only 7/16 UNF, so was it those?
ta
Chris
EDIT: Ok, pretty sure its M10 x 1.25 as its got a 17mm head on the bolt in there already.
[Edited on 25/9/06 by the_fbi]
|
|
|
|
|
Wadders
|
| posted on 25/9/06 at 07:55 PM |
|
|
It will deffo be metric, and prolly fine.
|
|
|
mark chandler
|
| posted on 25/9/06 at 10:31 PM |
|
|
Definately metric fine, M10 sounds about right.
|
|
|
