Gday guys

just wondering what to people do for a rear Sprocket gear for a chain driven mid engined bec

do you modify an existing one from the factory

do you get yours made to order and if so how is it done?

if anyone has any photos that would be great.

Thanks

I'm using a standard R1 sprocket on mine at the moment. Iv'e had to get the diff machined for it to fit, but it means that even if I do have to have one made with more teeth, at least the other dimensions will still be standard.

Martin.

Check out a bike mag there is a place called B&C sprocket express (if i remember right) they make them up in ali to what you want with more or less teeth depending on what you want....top end or acceleration....go bigger like a crosser for acceleration.

Talon Engineering made me one for a Reliant axle.
Try:

LINK

44 Lynx Trading Estate
Yeovil
Somerest
BA20 2NZ
England

Tel: +44 (0) 1935 471508
Fax: +44 (0) 1935 431825

Doh! just spotted your location

[Edited on 17/1/06 by trikerneil]