I have some nice aftermarket steel rims I want to put on ..
Anyone know the IVA position on rims other than correct tyre & rim fit sizes?

cheers
jon

quote:

---

Originally posted by johnemms
I have some nice aftermarket steel rims I want to put on ..
Anyone know the IVA position on rims other than correct tyre & rim fit sizes?

cheers
jon

---

i'm sure the manual would be the best place to start
can't think of any specifics in the manual, except the edge of the wheel mustn't stick out past the arches/cycle wings
other than that, i don't think i understand the question either

I thought it was me

I don't think there are any 'specified' requirements as long as they are not ridiculously over/under sized and are legal and safe?

Sorry can't be much more help than that.

I bought some steel wheels ages ago made in USA on the inner rims..
Just wondered if it would be a problem ...
Got all the right nuts etc..

[img][/img]

[img][/img]
cheers
jon

[Edited on 12/8/11 by johnemms]

Just thought of another requirement... They have to be round! Don't think that mentioned in the IVA manual though

Seriously, there's no standard requirement (like an E-mark). those should be fine.

Cheers...
fitting some 185/70/13 yokohamas on tomorow then!!

jon

More importantly, the tyre speed rating must be correct considering the expected max speed of the vehicle.

OT - those are nice looking rims.

I think center caps like knock off's are not allowed

Just wondering who the manufacturer is as in Canada I cant find anything like that Here or in the USA that is made in 4 bolt 4.25 x4

Thanks