Board logo

2 SVA clarifications
02GF74 - 13/11/06 at 02:41 PM

1. The 127 mm exclusion zone around the steering wheel.
- does this mean the lower dash edge is exempt from the radiussing stuff if it falls within the zone?


2. front wings
- when viewed vertically from above, does the whole tyre need to be covered or just the wheel
i.e. can the wings be fitted so the bit of tyre in front of the wheel can be seen as this would allow the wings to cover more of the rear of the tyre preventing crap being thrown up. (I haven't found the place in the manual that states this clearly).

Marcus - 13/11/06 at 02:48 PM

1. Yes

2. Just the wheel

russbost - 13/11/06 at 03:43 PM

Confirmed - take a line vertically upwards from the plan form of the wheel, the wing must cover this

02GF74 - 13/11/06 at 04:22 PM

quote:
Originally posted by russbost
Confirmed - take a line vertically upwards from the plan form of the wheel, the wing must cover this


okey dokey; but what about the side wall - most tyres protrude a bit pastthe wheel?

just curious as this was an SVA failure - I didn;t ask to have it clraified but I'm sure the arch covered the weel but probably not the tyre.

not that it matters too much since I have new special SVA friendly wheels and be making stays for the new wings so it should be ok this time round.