Richard Quinn
|
| posted on 22/12/08 at 09:56 AM |
|
|
K&N Challenger - SVA issues?
Has anyone used the K&N Challenger type filter (smaller chrome version of the universal airbox shown below but uses the same clip arrangement for
fastening) in a protruding through bonnet scenario. I know there are lots of other options available but I need something squarish rather than a large
rectangle. The Pipercross PX 300 foam jobbies mean that I would need a very tall (125mm) version to allow it to breath sufficiently for around 150bhp.
So, with judicious use of a foam pre-filter around the outside, do you reckon I could I would have any SVA related issues?
TIA
Whoops, forgot the photo...
Image deleted by owner
[Edited on 22/12/08 by Richard Quinn]
|
|
|
|
|
iank
|
| posted on 22/12/08 at 10:31 AM |
|
|
The clips/bands look a little sharp for exposed running, also be careful around the lid, though that would be easier to radius.
I think it could be fixed with some suitable trim though.
--
Never argue with an idiot. They drag you down to their level, then beat you with experience.
Anonymous
|
|
|
