luke2152
|
| posted on 10/1/15 at 03:21 PM |
|
|
engine number
Took me forever to find my engine number and when I did it is extremely faintly stamped on (apparently the norm on mx5 engines). Anyway even after
cleaning it up with a wire brush you can only read a few digits of it which correspond correctly with the engine number on the doner v5. Is this
going to be a problem on my IVA?
|
|
|
|
|
Slimy38
|
| posted on 10/1/15 at 03:44 PM |
|
|
I scrubbed mine with some degreaser then took a photo of it, the flash actually made it contrast much better. It is ridiculously faint though, they
must have stamped them on with a bunch of flowers rather than a hammer.
I would hope the inspector has some common sense and realises it's highly unlikely for a replacement engine to have the same digits. Especially
if it's the last few digits that are visible.
|
|
|
coozer
|
| posted on 11/1/15 at 02:11 PM |
|
|
I used electrolysis on mine to bring it up successfully.
1972 V8 Jago
1980 Z750
|
|
|
