Krismc
|
| posted on 2/11/08 at 04:34 PM |
|
|
Seat belts for sva
are my willans harness ends alright for sva- where they attach behind seats???
they are metal clips can i get a plastic/rubber covers for them????
Built, Ivaed, Drove and now Sold - 2011 MNR VORTX RT+ 2000cc Zetec on R1 Throttle boddies.
|
|
|
|
|
eznfrank
|
| posted on 2/11/08 at 04:53 PM |
|
|
When you say "clips" are they the quick release type? I don't think they're SVA ok. For the bolt type you can usually pick
up a plastic cover from a tin top.
|
|
|
rb968
|
| posted on 2/11/08 at 05:45 PM |
|
|
The Westfield we just SVA's had their clip on shoulder straps. Westfield supply triangular pouches to slide over the clips. Cut a slot in the
underside of the material for the eye bolt to allow it to clip on. However SVa man could still feel sharp edges so we added some rubber utrim and
sticky backed foam onto the clip. Has fallen off now!
Rich
|
|
|
martin1973
|
| posted on 2/11/08 at 05:45 PM |
|
|
the clip type passed sva fine,
i made some small leathette covers for mine 10min job TBH
martin
|
|
|
Krismc
|
| posted on 2/11/08 at 06:17 PM |
|
|
yea i have a 75mm bar sticking out chassis with a eyebolt on and quick release willans harnesses on them. rather have the westfield items than make
some if i can.
Built, Ivaed, Drove and now Sold - 2011 MNR VORTX RT+ 2000cc Zetec on R1 Throttle boddies.
|
|
|
rb968
|
| posted on 2/11/08 at 06:22 PM |
|
|
Theres nothing to them honestly. Two triangular bits of leatherette material stitched into a pocket. We were a bit disappointed when we got them. Plus
you may need to fill them with some padding. To clarify they only cover the harness clips not all of the eye bolt support tube/bar if that what you
are concerned about.
|
|
|
Krismc
|
| posted on 2/11/08 at 06:29 PM |
|
|
ill get a pic up and see whats possiblity of failing
Built, Ivaed, Drove and now Sold - 2011 MNR VORTX RT+ 2000cc Zetec on R1 Throttle boddies.
|
|
|
maximill666
|
| posted on 2/11/08 at 10:48 PM |
|
|
I have quick release ends on my Sabelt harneses and they passed fine when SVA'd a few weeks ago, I just fitted some u trim around the edges just
in case.
The VOSA examiner told me that the area between the rear of the seats and the roll bar was exempt from the minimum radius rule & there was no
problem with them being the quick release type.
Regards,
Lee
|
|
|
