dirty130
|
| posted on 29/12/06 at 05:39 PM |
|
|
Bodgey work
I hate ally its a pain loads of scratches a pain to cut easy to bend hehe. But i have just finished fittin the drivers side front panel and there is
loads of scratches and hammer marks in it. i want to buff them out has any 1 got any ideas of what to use? I have a air gun with a sanding pad on im
going to get a mop pad for it. Just would like some advise be fore i go spending all my pocket money. Thanks
It will fit wheres me hammer?
|
|
|
|
|
Catpuss
|
| posted on 29/12/06 at 05:48 PM |
|
|
Look a the polishing kits for m/cycle ally frames. Thats one alternative with the big buffing wheels and polishing compounds.
|
|
|
mike.williams1
|
| posted on 29/12/06 at 07:34 PM |
|
|
bodgey work
use scotch pads and aotosol. works a treat
|
|
|
zetec7
|
| posted on 30/12/06 at 08:04 AM |
|
|
Good advice - Scotchbrite pads and Autosol don't remove much metal..a good thing, unless you want to end up with aluminum foil body work!
http://www.freewebs.com/zetec7/
|
|
|
