dirty130
|
posted on 10/1/07 at 04:05 PM |
|
|
Prop Shaft Torq
Hello,Im just about to panel up my gearbox tunnel and before i do i want to make sure my propshaft is nice and tight, but er not to tight does any 1
have an idea of the torq that the bolts should be at? gear box and diff end thanks
It will fit wheres me hammer?
|
|
|
NS Dev
|
posted on 10/1/07 at 05:07 PM |
|
|
good and tight, with loctite, using a std length 1/2" drive ratchet, or in more accurate terms, go for approx 80 to 85 Nm
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|
NS Dev
|
posted on 10/1/07 at 05:08 PM |
|
|
PS that's assuming M10 x 1.25 bolts
Retro RWD is the way forward...........automotive fabrication, car restoration, sheetmetal work, engine conversion
retro car restoration and tuning
|
|