locoboy
|
| posted on 26/4/07 at 07:59 AM |
|
|
Sierra uprights
Have any of you needed to grind smooth any of the casting imperfections or edges on the sierra uptights prior to SVA or have many of you passed
without getting the grinder on them?
Thanks
ATB
Locoboy
|
|
|
|
|
graememk
|
| posted on 26/4/07 at 08:05 AM |
|
|
mine were all ok mate, why not just smooth some pu or silocone over the high or rough bits
|
|
|
locoboy
|
| posted on 26/4/07 at 08:11 AM |
|
|
I was more on about the edges on the upright around the 'lug' where the track rod end bolts to and where the bottom ball joint attaches to
and the sharp bits where the bolt goes through when clamping p the mushroom adaptors.
ATB
Locoboy
|
|
|
graememk
|
| posted on 26/4/07 at 08:12 AM |
|
|
i dont think the sva guys ball thingy will go in there
|
|
|
flange nut
|
| posted on 26/4/07 at 12:36 PM |
|
|
I rounded the edges on my Cortina uprights, just to be sure.
Geoff
|
|
|
