dirty130
|
| posted on 29/4/07 at 07:54 AM |
|
|
Vents
I have just test fitted my plastics only find there is a scratch on the near side of the bonnet (not my doing). I was very upset because i dropped my
nose cone and scuffed it(thats not half as bad as i thought). So as the engine bay needs more cooling i thoughts a nice vent would be good to cool the
engine bay and hide that scratch. Could any 1 recomend a company and vent? the scratch is on the near side on the curve on the bonnet near the
scuttle.
It will fit wheres me hammer?
|
|
|
|
|
rusty nuts
|
| posted on 29/4/07 at 09:10 AM |
|
|
How about cutting a hole, painting the edges to match the bonnet and bonding some fine mesh on the underside? Nothing to spoil the bonnet line , would
look good and not cost a lot.
|
|
|
mangogrooveworkshop
|
| posted on 29/4/07 at 01:09 PM |
|
|
This site does it the hellfire indy link
|
|
|
zetec
|
| posted on 29/4/07 at 07:40 PM |
|
|
Or this....JPG)
" I only registered to look at the pictures, now I'm stuck with this username for the rest of my life!"
|
|
|
.jpg)
