Using a xflow on an engine transplant and have looked "high and low" for the little wire (with an L-shaped rubber boot) connection to go on the back of the gearbox for reversing light wire. Anyone got one floating around? If I remember well, the wire is only about 6 inches long, just enough to go through transmission tunnel where it then connects into the main wiring loom.

Would/Could use a spade connector but there is very little space in transmission tunnel and the original ford connection is similar to brass press you would find on a jacket so mega-difficult to solder/make something other than the standard connection. ANY help would be greatly appreciated.

Thanks in advance - Andy

On my Nissan transmission, I couldn't find the correct wire either, and when I thought I did, it was very hard to reach. I ended up forgetting it and installing a switch on the dash. Easy. I don't think your IVA requires it does it?

IVA does now require a reversing light unlike the SVA