Has any body come across a way of making ford hubs fit MX5 uprights, does any body currently make alloy hubs for this? I know cortina uprights are
very simular to the MX5 and there is the Rally Design option but I was looking for a cheaper way round it.
I know I could make PDC adaptors but I would prefer to just make new hubs for a direct fit.
[Edited on 14/3/12 by Talon Motorsport]
Redrill the mx5 hubs, then use studs with a smaller knurled/splined section. That's how I've done it for recent customer work sent overseas.
No complaints yet, though there's not a lot of metal left on the outside after all is done.
Cheers,
nev.
Am I right in thinking you have to replace whole hub/bearing as a unit if bearings are shot?
If so then consider that cost when doing your sums.....
quote:
Originally posted by Neville Jones
Redrill the mx5 hubs, then use studs with a smaller knurled/splined section. That's how I've done it for recent customer work sent overseas. No complaints yet, though there's not a lot of metal left on the outside after all is done.
Cheers,
nev.