Hi All

Does anybody know any contacts to get new bolt on style drive shafts for a sierra??

I have tried Fords but they can not longer get these .

Any suggestions?????

Cheers

forum member nsdev gave this reply to me when i asked about custom length shafts for a granada - same as sierra

Yep, pleased to be of help!

Ring Geoff Berrisford (GB Engineering) on 01270 841081. You need to tell him the lengths from the inside of each "cup" at the wheel and diff ends (presuming you are using Lobro type shafts)

You will want the "long spline, standard" driveshafts. (he also does stronger ones and "unbreakable" gundrilled F1 spec ones)

think price was about 80 quid each...


atb


steve

[Edited on 28/9/05 by steve_gus]

you could try elliston kitparts.they should be able to supply them & any other sierra bits you might need.call them on 01842 890855

Cheers, i will give them a try, i am sure they will be able to help.

I am also after the outer section that goes through the hub, Not sure on the technical name ??

Cheers for the replys.

one of these?

http://www.locostbuilders.co.uk/viewthread.php?tid=29855

like rocking horse poo apparently..

Hi

I have the flange (bit with the studs on) i am after the bit that slides through this and the drivbe shaft bolts to??

I did not think they would be that hard to get hold of..... Supprising ah !!!

try elliston kitparts.he has several sierra back ends in stock(disc & drum brake type) im sure he will be able to help as i have found them very helpful in the past.just remember which side you need as they are handed.also use a new retaining nut,still avaliable from ford i think.hope this helps.not sure how much carriage would be though.

ok, Cheers i will give him a try.

Like you said he may have new items, worth a try.


Thanks again