Hi all,

Busy day building my BEC, I,m now on to the rear subframe to take the diff and wishbones before completing the tunnel.

Has anyone got the dimensions for the 1/4" steel brackets to bolt the diff to ? the best I can find by searching is 104mm between holes.

Also are the halfshafts handed as looking at various pictures the pinion sits along the central axis of the chassis (or should I jink it over a bit ?).




Cheers Mark

The diff nose is central in the car, the crownwheel is offset so one shaft is longer than the other. The nearside is a left hand thread hub nut as well.