Hi all, Iam still trying to get my clutch pushrod fixed to the pedal in a vertical position however I have now run out of thread and if I continue the thread down the pushrod I will not have enough travel.

So can I put spacers behind the pedal box and before the M/C so the M/C is further away and will both allow my pedal position and enough travel??

Thanks

Yes!

You will want to make the spacer the same profile as the master cyl flange or there will be a gap behind it that goes from inside the car into the engine bay, but other than that, no probs, just need longer bolts.

thanks dev I asctually cut a small notch in the pedal to create the clearance.