This afternoon I assembled my front right corner consisting of

tina upright- tina hub- wilwood disk and 4pots-wheel-wheel nuts

from the inside it all looks ok, but from the outside (visible side) it looks like the disk is way too far away from the exterior face of the wheel. this is the worst description ever, sorry

Is this right? or am i just used to looking at disks which are mounted between the hub and wheel instead of behind the hub like the tina ones.

Obviously this could all be changed with different offset wheels, i can't remember what mine are, I will check tomorrow

any comments, advice or observations???

[Edited on 7/5/06 by liam.mccaffrey]

Shoot us a pic, then we'll know if there appears to be a problem. From the description, though, it sound pretty normal (don't forget, if you're looking at front-wheel drive cars, the normal wheel offset makes the rotors look like they're closer to the wheels than they are on rear-wheel drive cars...)

ill do a pic tomorrow, thanks.

i think its normal just wanted to check

They do look a long way in on Cortina hubs. My mate fitted 15" wheels and you could practically change the pads without taking the wheel off. With the smaller calipers it will look even emptier.

Image deleted by owner

here it is, what do you think??

Looks about right to me