This is a long shot I know but I'm wondering if any of the southern guys who might be going to Box Hill tomorrow might happen to have a spare Male brake pipe fitting, I need one to fit into a Wilwood master cylinder but by the time I got to my local motor factors today they were shut and Halfrauds are next to useless!!

Rich.

is it standard 10mm thread?

I am using Wilwood and I believe the thread in the m/cylinder is NPT. Rally Design keep NPT to metric adapters.

John

Rich,ive got some metric ones ill bring morra,just hope they fit
John,is npt same as unf?

[Edited on 3/2/07 by theconrodkid]

[Edited on 3/2/07 by theconrodkid]

Isnt it 7/16" UNF??

sneaky suspcision it's UNF as I beliew they are american fittings on Wilwoods!

I think you are right Andrew, I've just checked my invoice from Rally Design and it looks as if the feed from the reservoir is 7/16"UNF for the 1/4" pipe and the other 3/8"UNF. the old memory's not what it used to be(and it never was that good)!!

Rich,ill have a look for some unf in the morning,bring some metric as well.

You're a star mate, thanks.

I know it's unlikely but no-one also happenns to have an old flexi brake pipe as I have a mini one but it's about an inch too short, I'm sorting the brakes on my car trailer.

Rich.

its your lucky day rich

I'll check my stash of brake pipe fottings too, i'm sure i have some imperial stuff like the ceptic tanks use on the other side of the pond

Right, I know this is a very long shot but you don't happen to have a spare Ferrari lying around that I could have do you??