Hi chaps,

I'm assembling my cortina hubs and wondered if anyone had the haynes manual handy, I need to know how tight to torque the bolts that hold on the brake disc and also the main hub nut?

Cheers, James

Disc to hub: 41 to 47 Nm.
Caliper to upright: 62 to 69 Nm.

If you are referring to the nut on the end of the stub axle, this is not torqued as the other two are, it is carefully adjusted to just absorb any rock in the wheel bearings, without preloading them, and then the nut is retained by the serrated washed and held with a split pin,

HTH
Mal

For the hub nut the book says torque to 27lb ft then undo by 1/4 turn.


[Edited on 12/5/07 by big_wasa]

Finally getting to fit them eh

Jason

quote:

---

Originally posted by Deckman001
Finally getting to fit them eh

Jason

---