Hi all,

I attempted to fit my master cylinder today (off a Sierra) but because of how the reinforced bulkhead has been welded (slightly inboard of the rest of the bulkhead) the brake reservoir fouls on it.

Can i simply turn the reservoir around through 180 degrees as it fits like this or will this cause problems?

Or should I just bite the bullet and make a spacer and mount it the right way round?

Thanks in advance.

Chris.

[Edited on 30/11/07 by Nosbod]

Couple of washers on each bolt between the MC and bulkhead will do.

Pat...

Fiat connectors as in a recent post and a remote reservoir?

Nosbod like you said just turn it around

Thanks for the advice guys, now i can get on with routing the pipes.